1 files changed, 59 insertions, 0 deletions
diff --git a/Bindings/arm/l2cc.txt b/Bindings/arm/l2cc.txt
new file mode 100644
index 0000000000000..b513cb8196fef
--- /dev/null
+++ b/Bindings/arm/l2cc.txt
@@ -0,0 +1,59 @@
+* ARM L2 Cache Controller
+
+ARM cores often have a separate level 2 cache controller. There are various
+implementations of the L2 cache controller with compatible programming models.
+The ARM L2 cache representation in the device tree should be done as follows:
+
+Required properties:
+
+- compatible : should be one of:
+  "arm,pl310-cache"
+  "arm,l220-cache"
+  "arm,l210-cache"
+  "bcm,bcm11351-a2-pl310-cache": DEPRECATED by "brcm,bcm11351-a2-pl310-cache"
+  "brcm,bcm11351-a2-pl310-cache": For Broadcom bcm11351 chipset where an
+     offset needs to be added to the address before passing down to the L2
+     cache controller
+  "marvell,aurora-system-cache": Marvell Controller designed to be
+     compatible with the ARM one, with system cache mode (meaning
+     maintenance operations on L1 are broadcasted to the L2 and L2
+     performs the same operation).
+  "marvell,aurora-outer-cache": Marvell Controller designed to be
+     compatible with the ARM one with outer cache mode.
+  "marvell,tauros3-cache": Marvell Tauros3 cache controller, compatible
+     with arm,pl310-cache controller.
+- cache-unified : Specifies the cache is a unified cache.
+- cache-level : Should be set to 2 for a level 2 cache.
+- reg : Physical base address and size of cache controller's memory mapped
+  registers.
+
+Optional properties:
+
+- arm,data-latency : Cycles of latency for Data RAM accesses. Specifies 3 cells of
+  read, write and setup latencies. Minimum valid values are 1. Controllers
+  without setup latency control should use a value of 0.
+- arm,tag-latency : Cycles of latency for Tag RAM accesses. Specifies 3 cells of
+  read, write and setup latencies. Controllers without setup latency control
+  should use 0. Controllers without separate read and write Tag RAM latency
+  values should only use the first cell.
+- arm,dirty-latency : Cycles of latency for Dirty RAMs. This is a single cell.
+- arm,filter-ranges : <start length> Starting address and length of window to
+  filter. Addresses in the filter window are directed to the M1 port. Other
+  addresses will go to the M0 port.
+- interrupts : 1 combined interrupt.
+- cache-id-part: cache id part number to be used if it is not present
+  on hardware
+- wt-override: If present then L2 is forced to Write through mode
+
+Example:
+
+L2: cache-controller {
+        compatible = "arm,pl310-cache";
+        reg = <0xfff12000 0x1000>;
+        arm,data-latency = <1 1 1>;
+        arm,tag-latency = <2 2 2>;
+        arm,filter-ranges = <0x80000000 0x8000000>;
+        cache-unified;
+        cache-level = <2>;
+	interrupts = <45>;
+};