1 files changed, 0 insertions, 63 deletions
diff --git a/Bindings/net/wireless/marvell-sd8xxx.txt b/Bindings/net/wireless/marvell-sd8xxx.txt
deleted file mode 100644
index c421aba0a5bca..0000000000000
--- a/Bindings/net/wireless/marvell-sd8xxx.txt
+++ /dev/null
@@ -1,63 +0,0 @@
-Marvell 8897/8997 (sd8897/sd8997) SDIO devices
-------
-
-This node provides properties for controlling the marvell sdio wireless device.
-The node is expected to be specified as a child node to the SDIO controller that
-connects the device to the system.
-
-Required properties:
-
-  - compatible : should be one of the following:
-	* "marvell,sd8897"
-	* "marvell,sd8997"
-
-Optional properties:
-
-  - marvell,caldata* : A series of properties with marvell,caldata prefix,
-		      represent calibration data downloaded to the device during
-		      initialization. This is an array of unsigned 8-bit values.
-		      the properties should follow below property name and
-		      corresponding array length:
-	"marvell,caldata-txpwrlimit-2g" (length = 566).
-	"marvell,caldata-txpwrlimit-5g-sub0" (length = 502).
-	"marvell,caldata-txpwrlimit-5g-sub1" (length = 688).
-	"marvell,caldata-txpwrlimit-5g-sub2" (length = 750).
-	"marvell,caldata-txpwrlimit-5g-sub3" (length = 502).
-  - marvell,wakeup-pin : a wakeup pin number of wifi chip which will be configured
-		      to firmware. Firmware will wakeup the host using this pin
-		      during suspend/resume.
-  - interrupt-parent: phandle of the parent interrupt controller
-  - interrupts : interrupt pin number to the cpu. driver will request an irq based on
-		 this interrupt number. during system suspend, the irq will be enabled
-		 so that the wifi chip can wakeup host platform under certain condition.
-		 during system resume, the irq will be disabled to make sure
-		 unnecessary interrupt is not received.
-
-Example:
-
-Tx power limit calibration data is configured in below example.
-The calibration data is an array of unsigned values, the length
-can vary between hw versions.
-IRQ pin 38 is used as system wakeup source interrupt. wakeup pin 3 is configured
-so that firmware can wakeup host using this device side pin.
-
-&mmc3 {
-	status = "okay";
-	vmmc-supply = <&wlan_en_reg>;
-	bus-width = <4>;
-	cap-power-off-card;
-	keep-power-in-suspend;
-
-	#address-cells = <1>;
-	#size-cells = <0>;
-	mwifiex: wifi@1 {
-		compatible = "marvell,sd8897";
-		reg = <1>;
-		interrupt-parent = <&pio>;
-		interrupts = <38 IRQ_TYPE_LEVEL_LOW>;
-
-		marvell,caldata_00_txpwrlimit_2g_cfg_set = /bits/ 8 <
-	0x01 0x00 0x06 0x00 0x08 0x02 0x89 0x01>;
-		marvell,wakeup-pin = <3>;
-	};
-};