src/sys/modules/bhnd/siba, branch main

Remove residual blank line at start of Makefile

2024-07-15T22:43:39Z

This is a residual of the $FreeBSD$ removal. MFC After: 3 days (though I'll just run the command on the branches) Sponsored by: Netflix

sys: Remove $FreeBSD$: one-line sh pattern

2023-08-16T17:54:58Z

Remove /^\s*#[#!]?\s*\$FreeBSD\$.*$\n/

siba(4): Add support for devices have neither PMU nor PWRCTL support.

2017-11-28T00:42:44Z

Very early BHND Wi-Fi devices (e.g. BCM4318) do not support any form of dynamic clock control; on these devices, any PMU requests that cannot be met by the device's fixed clock state will return an appropriate error code. Approved by: adrian (mentor, implicit) Sponsored by: The FreeBSD Foundation

bhnd(4): extend the PMU APIs to support bwn(4)

2017-11-22T20:27:46Z

The bwn(4) driver requires a number of extensions to the bhnd(4) PMU interface to support external configuration of PLLs, LDOs, and other parameters that require chipset or PHY-specific workarounds. These changes add support for: - Writing raw voltage register values to PHY-specific LDO regulator registers (required by LP-PHY). - Enabling/disabling PHY-specific LDOs (required by LP-PHY) - Writing to arbitrary PMU chipctrl registers (required for common PHY PLL reset support). - Requesting chipset/PLL-specific spurious signal avoidance modes. - Querying clock frequency and latency. Additionally, rather than updating legacy PWRCTL support to conform to the new PMU interface: - PWRCTL API is now provided by a bhnd_pwrctl_if.m interface. - Since PWRCTL is only found in older SSB-based chipsets, translation from bhnd(4) bus APIs to corresponding PWRCTL operations is now handled entirely within the siba(4) driver. - The PWRCTL-specific host bridge clock gating APIs in bhnd_bus_if.m have been lifted out into a standalone bhnd_pwrctl_hostb_if.m interface. Approved by: adrian (mentor, implicit) Sponsored by: The FreeBSD Foundation Differential Revision: https://reviews.freebsd.org/D12664

sys/modules: normalize .CURDIR-relative paths to SRCTOP

2017-03-04T10:10:17Z

This simplifies make output/logic Tested with: `cd sys/modules; make ALL_MODULES=` on amd64 MFC after: 1 month Sponsored by: Dell EMC Isilon

Revert r308107

2016-10-30T22:18:22Z

Requested by: jhb

- Fix `make` in sys/modules/bhnd

2016-10-30T15:56:42Z

Approved by: landonf Differential Revision: https://reviews.freebsd.org/D7774

bhnd(4): Implement common API for IOST/IOCTL register access and core reset

2016-09-24T04:08:16Z

- Added bhnd(4) bus APIs for per-core ioctl/iost register access. - Updated reset/suspend bhnd(4) APIs for compatibility with ioctl/iost changes. - Implemented core reset/suspend support for both bcma(4) and siba(4). - Implemented explicit release of all outstanding PMU requests at the bus level when putting a core into reset. Approved by: adrian (mentor, implicit) Differential Revision: https://reviews.freebsd.org/D8009

Implement a generic bhnd(4) device enumeration table API.

2016-09-03T23:57:17Z

This defines a new bhnd_erom_if API, providing a common interface to device enumeration on siba(4) and bcma(4) devices, for use both in the bhndb bridge and SoC early boot contexts, and migrates mips/broadcom over to the new API. This also replaces the previous adhoc device enumeration support implemented for mips/broadcom. Migration of bhndb to the new API will be implemented in a follow-up commit. - Defined new bhnd_erom_if interface for bhnd(4) device enumeration, along with bcma(4) and siba(4)-specific implementations. - Fixed a minor bug in bhndb that logged an error when we attempted to map the full siba(4) bus space (18000000-17FFFFFF) in the siba EROM parser. - Reverted use of the resource's start address as the ChipCommon enum_addr in bhnd_read_chipid(). When called from bhndb, this address is found within the host address space, resulting in an invalid bridged enum_addr. - Added support for falling back on standard bus_activate_resource() in bhnd_bus_generic_activate_resource(), enabling allocation of the bhnd_erom's bhnd_resource directly from a nexus-attached bhnd(4) device. - Removed BHND_BUS_GET_CORE_TABLE(); it has been replaced by the erom API. - Added support for statically initializing bhnd_erom instances, for use prior to malloc availability. The statically allocated buffer size is verified both at runtime, and via a compile-time assertion (see BHND_EROM_STATIC_BYTES). - bhnd_erom classes are registered within a module via a linker set, allowing mips/broadcom to probe available EROM parser instances without creating a strong reference to bcma/siba-specific symbols. - Migrated mips/broadcom to bhnd_erom_if, replacing the previous MIPS-specific device enumeration implementation. Approved by: adrian (mentor) Differential Revision: https://reviews.freebsd.org/D7748

Add modules support for the bhnd code.

2016-02-26T03:34:32Z

Submitted by: Landon Fuller Obtained from: https://github.com/landonf/freebsd/compare/user/landonf/bcm4331-CURRENT