src/sys/modules/ipdivert, branch release/13.2.0 FreeBSD source tree https://cgit-dev.freebsd.org/src/atom?h=release%2F13.2.0 2017-03-04T10:10:17Z sys/modules: normalize .CURDIR-relative paths to SRCTOP 2017-03-04T10:10:17Z Enji Cooper ngie@FreeBSD.org 2017-03-04T10:10:17Z urn:sha1:193d9e768ba63fcfb187cfd17f461f7d41345048 This simplifies make output/logic Tested with: `cd sys/modules; make ALL_MODULES=` on amd64 MFC after: 1 month Sponsored by: Dell EMC Isilon Move most of the 15 variations on generating opt_inet.h and 2014-08-04T22:37:02Z Warner Losh imp@FreeBSD.org 2014-08-04T22:37:02Z urn:sha1:aeaed508982227551b2748339033bb2483382b4d opt_inet6.h into kmod.mk by forcing almost everybody to eat the same dogfood. While at it, consolidate the opt_bpf.h and opt_mroute.h targets here too. Use src.opts.mk in preference to bsd.own.mk except where we need stuff 2014-05-06T04:22:01Z Warner Losh imp@FreeBSD.org 2014-05-06T04:22:01Z urn:sha1:c6063d0da8e1f8d8452b0c2ee1c7ad718c1a7052 from the latter. Fix 'make depend'. 2012-02-16T21:57:50Z Ulrich Spörlein uqs@FreeBSD.org 2012-02-16T21:57:50Z urn:sha1:f7e784d50beec216e14b6032fbbc6b6c478546f9 Fix ip_divert handling of inet and inet6 and module building some more. 2012-01-22T02:16:31Z Bjoern A. Zeeb bz@FreeBSD.org 2012-01-22T02:16:31Z urn:sha1:aa57e971bc608ca716f69efe16644ae6e952546e Properly sort the "carp" case in modules/Makefile after it was renamed. Reported by: bde (most) Reviewed by: bde MFC after: 3 days Add possibility to pass IPv6 packets to a divert(4) socket. 2011-06-27T12:21:11Z Gleb Smirnoff glebius@FreeBSD.org 2011-06-27T12:21:11Z urn:sha1:812f1d32e7cce15029a7444cb70a46e464b14496 Submitted by: sem Convert IPDIVERT into a loadable module. This makes use of the dynamic loadability 2004-10-19T21:14:57Z Andre Oppermann andre@FreeBSD.org 2004-10-19T21:14:57Z urn:sha1:72584fd2c0708d9f7b879e916aeb99d63c911287 of protocols. The call to divert_packet() is done through a function pointer. All semantics of IPDIVERT remain intact. If IPDIVERT is not loaded ipfw will refuse to install divert rules and natd will complain about 'protocol not supported'. Once it is loaded both will work and accept rules and open the divert socket. The module can only be unloaded if no divert sockets are open. It does not close any divert sockets when an unload is requested but will return EBUSY instead.