1 files changed, 0 insertions, 65 deletions
diff --git a/Bindings/i2c/i2c-stm32.txt b/Bindings/i2c/i2c-stm32.txt
deleted file mode 100644
index ce3df2fff6c8..000000000000
--- a/Bindings/i2c/i2c-stm32.txt
+++ /dev/null
@@ -1,65 +0,0 @@
-* I2C controller embedded in STMicroelectronics STM32 I2C platform
-
-Required properties:
-- compatible: Must be one of the following
-  - "st,stm32f4-i2c"
-  - "st,stm32f7-i2c"
-- reg: Offset and length of the register set for the device
-- interrupts: Must contain the interrupt id for I2C event and then the
-  interrupt id for I2C error.
-- resets: Must contain the phandle to the reset controller.
-- clocks: Must contain the input clock of the I2C instance.
-- A pinctrl state named "default" must be defined to set pins in mode of
-  operation for I2C transfer
-- #address-cells = <1>;
-- #size-cells = <0>;
-
-Optional properties:
-- clock-frequency: Desired I2C bus clock frequency in Hz. If not specified,
-  the default 100 kHz frequency will be used.
-  For STM32F4 SoC Standard-mode and Fast-mode are supported, possible values are
-  100000 and 400000.
-  For STM32F7, STM32H7 and STM32MP1 SoCs, Standard-mode, Fast-mode and Fast-mode
-  Plus are supported, possible values are 100000, 400000 and 1000000.
-- dmas: List of phandles to rx and tx DMA channels. Refer to stm32-dma.txt.
-- dma-names: List of dma names. Valid names are: "rx" and "tx".
-- i2c-scl-rising-time-ns: I2C SCL Rising time for the board (default: 25)
-  For STM32F7, STM32H7 and STM32MP1 only.
-- i2c-scl-falling-time-ns: I2C SCL Falling time for the board (default: 10)
-  For STM32F7, STM32H7 and STM32MP1 only.
-  I2C Timings are derived from these 2 values
-- st,syscfg-fmp: Use to set Fast Mode Plus bit within SYSCFG when Fast Mode
-  Plus speed is selected by slave.
-	1st cell: phandle to syscfg
-	2nd cell: register offset within SYSCFG
-	3rd cell: register bitmask for FMP bit
-  For STM32F7, STM32H7 and STM32MP1 only.
-
-Example:
-
-	i2c@40005400 {
-		compatible = "st,stm32f4-i2c";
-		#address-cells = <1>;
-		#size-cells = <0>;
-		reg = <0x40005400 0x400>;
-		interrupts = <31>,
-			     <32>;
-		resets = <&rcc 277>;
-		clocks = <&rcc 0 149>;
-		pinctrl-0 = <&i2c1_sda_pin>, <&i2c1_scl_pin>;
-		pinctrl-names = "default";
-	};
-
-	i2c@40005400 {
-		compatible = "st,stm32f7-i2c";
-		#address-cells = <1>;
-		#size-cells = <0>;
-		reg = <0x40005400 0x400>;
-		interrupts = <31>,
-			     <32>;
-		resets = <&rcc STM32F7_APB1_RESET(I2C1)>;
-		clocks = <&rcc 1 CLK_I2C1>;
-		pinctrl-0 = <&i2c1_sda_pin>, <&i2c1_scl_pin>;
-		pinctrl-names = "default";
-		st,syscfg-fmp = <&syscfg 0x4 0x1>;
-	};