diff options
Diffstat (limited to 'Bindings/regulator/max8973-regulator.txt')
| -rw-r--r-- | Bindings/regulator/max8973-regulator.txt | 26 |
1 files changed, 25 insertions, 1 deletions
diff --git a/Bindings/regulator/max8973-regulator.txt b/Bindings/regulator/max8973-regulator.txt index 4f15d8a1bfd0..f80ea2fe27e6 100644 --- a/Bindings/regulator/max8973-regulator.txt +++ b/Bindings/regulator/max8973-regulator.txt @@ -2,12 +2,36 @@ Required properties: -- compatible: must be "maxim,max8973" +- compatible: must be one of following: + "maxim,max8973" + "maxim,max77621". - reg: the i2c slave address of the regulator. It should be 0x1b. Any standard regulator properties can be used to configure the single max8973 DCDC. +Optional properties: + +-maxim,externally-enable: boolean, externally control the regulator output + enable/disable. +-maxim,enable-gpio: GPIO for enable control. If the valid GPIO is provided + then externally enable control will be considered. +-maxim,dvs-gpio: GPIO which is connected to DVS pin of device. +-maxim,dvs-default-state: Default state of GPIO during initialisation. + 1 for HIGH and 0 for LOW. +-maxim,enable-remote-sense: boolean, enable reote sense. +-maxim,enable-falling-slew-rate: boolean, enable falling slew rate. +-maxim,enable-active-discharge: boolean: enable active discharge. +-maxim,enable-frequency-shift: boolean, enable 9% frequency shift. +-maxim,enable-bias-control: boolean, enable bias control. By enabling this + startup delay can be reduce to 20us from 220us. +-maxim,enable-etr: boolean, enable Enhanced Transient Response. +-maxim,enable-high-etr-sensitivity: boolean, Enhanced transient response + circuit is enabled and set for high sensitivity. If this + property is available then etr will be enable default. + +Enhanced transient response (ETR) will affect the configuration of CKADV. + Example: max8973@1b { |