diff options
Diffstat (limited to 'Bindings/serial/serial-peripheral-props.yaml')
| -rw-r--r-- | Bindings/serial/serial-peripheral-props.yaml | 41 |
1 files changed, 41 insertions, 0 deletions
diff --git a/Bindings/serial/serial-peripheral-props.yaml b/Bindings/serial/serial-peripheral-props.yaml new file mode 100644 index 000000000000..b4a73214d20d --- /dev/null +++ b/Bindings/serial/serial-peripheral-props.yaml @@ -0,0 +1,41 @@ +# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/serial/serial-peripheral-props.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: Common Properties for Serial-attached Devices + +maintainers: + - Rob Herring <robh@kernel.org> + - Greg Kroah-Hartman <gregkh@linuxfoundation.org> + +description: + Devices connected over serial/UART, expressed as children of a serial + controller, might need similar properties, e.g. for configuring the baud + rate. + +properties: + max-speed: + $ref: /schemas/types.yaml#/definitions/uint32 + description: + The maximum baud rate the device operates at. + This should only be present if the maximum is less than the slave + device can support. For example, a particular board has some + signal quality issue or the host processor can't support higher + baud rates. + + current-speed: + $ref: /schemas/types.yaml#/definitions/uint32 + description: | + The current baud rate the device operates at. + This should only be present in case a driver has no chance to know + the baud rate of the slave device. + Examples: + * device supports auto-baud + * the rate is setup by a bootloader and there is no way to reset + the device + * device baud rate is configured by its firmware but there is no + way to request the actual settings + +additionalProperties: true |