diff options
Diffstat (limited to 'documentation')
| -rw-r--r-- | documentation/content/en/books/handbook/serialcomms/_index.adoc | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/documentation/content/en/books/handbook/serialcomms/_index.adoc b/documentation/content/en/books/handbook/serialcomms/_index.adoc index 0ce967c73d..a5004d9821 100644 --- a/documentation/content/en/books/handbook/serialcomms/_index.adoc +++ b/documentation/content/en/books/handbook/serialcomms/_index.adoc @@ -490,10 +490,10 @@ The default [.filename]#/etc/ttys# configures support for the first four serial [.programlisting] .... -ttyu0 "/usr/libexec/getty std.9600" dialup off secure -ttyu1 "/usr/libexec/getty std.9600" dialup off secure -ttyu2 "/usr/libexec/getty std.9600" dialup off secure -ttyu3 "/usr/libexec/getty std.9600" dialup off secure +ttyu0 "/usr/libexec/getty std.115200" dialup off secure +ttyu1 "/usr/libexec/getty std.115200" dialup off secure +ttyu2 "/usr/libexec/getty std.115200" dialup off secure +ttyu3 "/usr/libexec/getty std.115200" dialup off secure .... When attaching a terminal to one of those ports, modify the default entry to set the required speed and terminal type, to turn the device `on` and, if needed, to change the port's `secure` setting. @@ -1163,12 +1163,12 @@ At the moment, the boot loader has no option equivalent to `-P` in the boot bloc ==== While it is not required, it is possible to provide a `login` prompt over the serial line. To configure this, edit the entry for the serial port in [.filename]#/etc/ttys# using the instructions in <<term-config>>. -If the speed of the serial port has been changed, change `std.9600` to match the new setting. +If the speed of the serial port has been changed, change `std.115200` to match the new setting. ==== === Setting a Faster Serial Port Speed -By default, the serial port settings are 9600 baud, 8 bits, no parity, and 1 stop bit. +By default, the serial port settings are 115200 baud, 8 bits, no parity, and 1 stop bit. To change the default console speed, use one of the following options: * Edit [.filename]#/etc/make.conf# and set `BOOT_COMCONSOLE_SPEED` to the new console speed. |